Some of the software is not so obvious to install, so here's how I got these popular applications going: Notice: The contained Repetier-Server is optiized for armv7l chips used on bigger Raspberry-Pis.It will not work on Pi Zero and Pi 1. Get your version of the Arduino IDE from. Note : La configuration « connexion » n’est utile que si vous souhaitez contrôler votre imprimante via USB. Go to the menu “Config”->”Printer Settings” or klick the button. Some firmwares like Repetier-Firmware correct the offset themself, so in this case offset should stay 0. In past articles I discussed the importance of the convenience factor in 3D printing. To run this application you need to install Microsoft.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |